HIKVISION Hik IP Receiver Pro User Manual

Check the parameter to enable spare ARC.
Spare ARC IP Address
Enter the IP Address of the spare ARC.
Spare ARC Port
Enter the spare ARC port number.
Device Heartbeat Interval
It ranges from 10 to 86400 seconds. It is 30 seconds by default.
Note
Used for the device which does not support Periodic Test or whose Periodic Test has not
been enabled. If the Periodic Test of a device has been enabled, then the device heartbeat
interval will be the same as that of this device.
Note
The SBN protocol supports conveying GPS informaon of the AX PRO panic buon.
DC-09
ID Token
Select between SIA-DCS and ADM-CID protocol.
IP Address
Enter the IP address of the ARC which supports SIA-DCS or ADM-CID protocol.
Port
Enter the port of the ARC. By default, it is 1025.
Spare ARC
Check the parameter to enable spare ARC.
Spare ARC IP Address
Enter the IP Address of the spare ARC.
Spare ARC Port
Enter the spare ARC port number.
Receiver Number
●
The number used for marking the Hik IP Receiver Pro as an
informaon receiver. You can
customize this parameter. Keep it the same with the number set on ARC.
●
The Enable is not checked by default. If it is checked, the receiver number will be
displayed in alarm event
informaon.
Line Card Number
By default, the line number is 0.
Enable Video Vericaon
Hik IP Receiver Pro User Manual
40

HIKVISION Hik IP Receiver Pro Specifications

General

Brand	HIKVISION
Model	Hik IP Receiver Pro
Category	Receiver
Language	English