HIKVISION HWN Series User Manual

Network Video Recorder User Manual
12
Button
Description
Button
Description
playback.
3.3 Event Playback
When you select the event playback mode, the system will analyze and mark videos that contain
the motion detection, line crossing detection, or intrusion detection information, .
Before You Start
● Ensure the camera has enabled Dual-VCA. You can enable it via the camera web browser
interface in Configuration → Video/Audio → Display Info. on Stream.
● Ensure your video recorder has enabled Save VCA Data. You can enable it in Configuration →
Record → Advanced.
Steps
1. Go to Playback.
2. Click Event.
3. Select a camera.
Figure 3-4 Event Playback
4. Position the cursor on playback window to show control bar.
Table 3-3 Button Description
Button
Description
Button
Description
Add tag.
Zoom in/out playback
image.
Clip video.
Lock/unlock video.

HIKVISION HWN Series Specifications

General

Model Series	HWN Series
Video Input	IP Video Input
Video Output	HDMI, VGA
Operating System	Embedded Linux
Type	NVR
Channels	Varies by model (4/8/16/32/64)
Recording Resolution	Up to 12MP
Resolution	Varies by model
Hard Drive Support	Yes
HDD Slots	Varies by model (1/2/4/8)
Max HDD Capacity	Up to 10TB per HDD
Network Interface	RJ45 10/100/1000Mbps
USB Interface	USB 2.0, USB 3.0
Operating Temperature	-10°C to +55°C (14°F to 131°F)
Operating Humidity	10% to 90%
Dimensions	Varies by model
Weight	Varies by model
Category	Network Video Recorder (NVR)
Power Supply	12 VDC