HIKVISION HWN Series User Manual

Network Video Recorder User Manual
76
Chapter 7 Maintenance
7.1 Restore Default
Steps
1. Click at the upper-right corner.
2. Select the restoring type.
Simple Restore
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the device to the inactive status, and leave all settings unchanged except restoring
user accounts.
3. Click Yes. The device will reboot automatically.
7.2 Search Log
The operation, alarm, exception and information of video recorder can be stored in logs, which
can be viewed and exported at any time.
Steps
1. Click at the upper-right corner.
2. Click More.
3. Click Log Information.
4. Set the search conditions.
5. Click Search.
7.3 System Service
Steps
1. Click at the upper-right corner.
2. Click More.
3. Click System Service.

HIKVISION HWN Series Specifications

General

Model Series	HWN Series
Video Input	IP Video Input
Video Output	HDMI, VGA
Operating System	Embedded Linux
Type	NVR
Channels	Varies by model (4/8/16/32/64)
Recording Resolution	Up to 12MP
Resolution	Varies by model
Hard Drive Support	Yes
HDD Slots	Varies by model (1/2/4/8)
Max HDD Capacity	Up to 10TB per HDD
Network Interface	RJ45 10/100/1000Mbps
USB Interface	USB 2.0, USB 3.0
Operating Temperature	-10°C to +55°C (14°F to 131°F)
Operating Humidity	10% to 90%
Dimensions	Varies by model
Weight	Varies by model
Category	Network Video Recorder (NVR)
Power Supply	12 VDC