HIKVISION HWN Series User Manual

Network Video Recorder User Manual
31
alarm.
Note
● Ensure your camera supports audio and light alarm linkage.
● Ensure the audio output and volume are properly configured.
● If you require to set audio and light parameters, please log into the network camera via
web browser to configure them.
3. Click Apply.
5.4 Recording Management
5.4.1 Storage Device
Initialize HDD
A newly installed hard disk drive (HDD) must be initialized before it can be used to save videos and
information.
Before You Start
Install at least an HDD to your video recorder. For detailed steps, refer to Quick Start Guide.
Steps
1. Go to Configuration → Record → Storage.
2. Select an HDD.
3. Click Init.
Repair Database
Repair an HDD that with error in database. Please operate it with the help of professional
technical support.
Add Network Disk
You can add the allocated NAS or IP SAN disk to the video recorder, and use it as a network HDD.
Steps
1. Go to Configuration → Record → Storage.
2. Click Add.
3. Select NetHDD.
4. Set Type as NAS or IP SAN.
5. Enter NetHDD IP address.
6. Click to search the available disks.

HIKVISION HWN Series Specifications

General

Model Series	HWN Series
Video Input	IP Video Input
Video Output	HDMI, VGA
Operating System	Embedded Linux
Type	NVR
Channels	Varies by model (4/8/16/32/64)
Recording Resolution	Up to 12MP
Resolution	Varies by model
Hard Drive Support	Yes
HDD Slots	Varies by model (1/2/4/8)
Max HDD Capacity	Up to 10TB per HDD
Network Interface	RJ45 10/100/1000Mbps
USB Interface	USB 2.0, USB 3.0
Operating Temperature	-10°C to +55°C (14°F to 131°F)
Operating Humidity	10% to 90%
Dimensions	Varies by model
Weight	Varies by model
Category	Network Video Recorder (NVR)
Power Supply	12 VDC