HIKVISION HWN Series User Manual

Network Video Recorder User Manual
43
Figure 6-6 NAT
2. Turn on Enable.
3. Select Mapping Type as Manual or Auto
Auto
The port mapping items are read-only, and the external ports are set
by the router automatically. You can click Refresh to get the latest
status of the port mapping.
Manual
Select an external port type. Click to edit External Port. You can
use the default external port No., or change it according to actual
requirements. External Port indicates the port No. for port mapping
in the router.
The value of the RTSP port No. should be 554 or between 1024 and
65535, while the value of the other ports should be between 1 and
65535 and the value must be different from each other. If multiple
devices are configured for the UPnP™ settings under the same router,
the value of the port No. for each device should be unique.
4. Set the virtual server of your router, including internal source port, external source port, etc.
The virtual server parameters shall be corresponding with your device port.
6.2.4 NTP
Your device can connect to a network time protocol (NTP) server to ensure that the system time is
accurate.
Steps
1. Go to Configuration → Network → General → NTP.
2. Turn on Enable.
3. Enter the parameters.
Interval
Time interval between two time synchronization with NTP server.

HIKVISION HWN Series Specifications

General

Model Series	HWN Series
Video Input	IP Video Input
Video Output	HDMI, VGA
Operating System	Embedded Linux
Type	NVR
Channels	Varies by model (4/8/16/32/64)
Recording Resolution	Up to 12MP
Resolution	Varies by model
Hard Drive Support	Yes
HDD Slots	Varies by model (1/2/4/8)
Max HDD Capacity	Up to 10TB per HDD
Network Interface	RJ45 10/100/1000Mbps
USB Interface	USB 2.0, USB 3.0
Operating Temperature	-10°C to +55°C (14°F to 131°F)
Operating Humidity	10% to 90%
Dimensions	Varies by model
Weight	Varies by model
Category	Network Video Recorder (NVR)
Power Supply	12 VDC