HIKVISION iDS-TCH44P-B

Chapter 4 Live View and Local Conguraon
4.1 Live View
4.1.1 Start/Stop Live View
Click to start live view. Click to stop live view.
4.1.2 Select Channel
Double click Channel 1 to enable the image stching channel, and double click Channel 2/Channel
3 to enable the license plate
recognion channel.
Note
Only devices with no less than 2 channels support channel selecon.
4.1.3 Select Image Display Mode
Click to display the image in 4:3/16:9/original/self-adapve display mode.
4.1.4 Select Stream Type
Click to select the stream type. It is recommended to select the main stream to get the high-
quality image when the network condion is good, and select the sub-stream to get the uent
image when the network condion is not good enough. The third stream is custom.
4.1.5 Capture Picture Manually
You can capture pictures manually on the live view image and save them to the computer.
Steps
1.
Click to start live view.
2.
Click
to capture a picture.
3.
Oponal: Click Conguraon → Local Conguraon to view the saving path of snapshots in live
view.
4.1.6 Record Manually
You can record videos manually on the live view image and save them to the computer.
Network Trac Camera (Mul-lens LPR Camera) User Manual
16