HIKVISION iDS-TCH44P-B

Note
The test is single-use. You cannot test the connecon repeatedly.
9.
Click Save.
5.1.3 Set Listening Host
The listening host can be used to receive the uploaded informaon and pictures of the device
arming alarm.
Before You Start
The listening service has been enabled for the listening host, and the network
communicaon with
the device is normal.
Steps
1.
Go to
Conguraon → Device Conguraon → System Conguraon → Network Parameters .
Figure 5-3 Set Listening Host
2.
Set ANPR IP Address and ANPR Port if you need to upload the alarm informaon.
3.
Set Listening Host IP Address and Listening Host Port, and check Enable Picture Uploading
Listening if you need to upload pictures.
Note
ANPR and listening conict with each other. When you enable listening host, pictures will be
uploaded via listening host in priority. When you disable listening and have set ANPR IP address
and port, pictures will be uploaded via ANPR protocol.
4.
Set Preferred DNS Address if you need to visit the device with domain name.
5.
Set Mulcast Address if you need to preview the picture via the mulcast group.
6.
Click Save.
Network Trac Camera (Mul-lens LPR Camera) User Manual
23