Network Traffic Camera • User Manual
56
Chapter 12 Application Mode Configuration
Purpose:
This chapter introduces the parameters configuration under different trigger mode. The supported
trigger modes vary according to the camera models.
Smart Mode
In this mode, target capture and license plate recognition are triggered by internal live video
analysis. Smart mode applies to road surveillance.
Go to Configuration > Device Configuration > Application Mode.
Select Application Mode as Smart Mode.
Select Total Lanes. Up to 3 lanes are supported.
Smart Mode Configuration
Select Capture Type. All and Motor Vehicle are selectable.
All: Capture and recognize pedestrian, non-motor vehicle and motor vehicle.
Motor Vehicle: Capture and recognize motor vehicle.
Draw rules line.
1) Click Draw Rules line.
To Next Page
Loading...
Need help?
General
