Network Traffic Camera • User Manual
48
Configure Picture
Purpose:
The camera supports dual-shutter. One shutter for video image and the other one for captured
image. You can configure shutter parameters for captured image.
Go to Configuration > Device Configuration > Image Parameters > Picture.
Captured Image Configuration
Check Enable License Plate Enhancement. Level adjustable from 0 to 100.
Check Contrast Enhancement.
1) Select mode as On, Time, Brightness.
Time: Activate the function on schedule. Set the start time and end time.
Brightness: Active the function automatically. Set the brightness threshold.
2) Set enhancement level from 0 to 100. Higher value means stronger effect.
3) Set Halo Suppression Level from 0 to 100. Higher value means stronger effect.
Configure ICR
Purpose:
IR Cut Filter is used to block or reflect infrared wavelengths but pass visible light. This series of
cameras support auto switch of ICR to realize the 24-hour surveillance.
ICR configuration is not supported by all camera models of this series.
Go to Configuration > Device Configuration > Image Parameters > ICR.
To Next Page
Loading...
