Select alarm input source in [Alarm Type]. If the alarm type is [Sensor Alarm], please
select relative sensor name and configure alarm linkage afterwards; or if the alarm type is
[Camera Alarm], please select the alarm link camera and sub type of alarm ([Video Loss],
[Motion Detection], [Video Tamper Alarm]) and configure alarm linkage afterwards; else if
the alarm source is [Exception], please select relative exception type and configure alarm
linkage afterwards.
[Arm Schedule]
Arm schedule for alarm linkage is set as 24-hour mode by default and the
configuration steps for arm schedule is basically the same as record schedule settings.
Users can set up to 8 arm periods for each day (Figure 6-30).
Figure 6-30 Arm Schedule Configuration for Alarm Linkage
[Record]
Click [Enable] and set pre-record / post-record time, and select recording camera(s)
to set camera recording for alarm linkage (Figure 6-31).
To Next Page
