Figure 6-31 Alarm Record Configuration
[PTZ]
Click [Enable] and set PTZ event for alarm linkage (Figure 6-32).
Select PTZ cameras and alarm link type (Preset/Patrol/Pattern) and select the
preset/patrol/pattern which should be linked to the alarm accordingly. Users can also set
a preset position to be returned to after alarm linkage event, and also duration time
before returning.
Figure 6-32 Alarm Link PTZ Configuration
[Relay]
Click [Enable] and set relay output for alarm linkage, there are continuous/post
output modes for relay configuration (Figure 6-33).
To Next Page
Loading...
