To Next Page

To Previous Page

Fingerprint Access Control Terminal·User Manual

time to 30min, the device will sleep after 30 min without any

operation.

Note: If you set the sleeping time to 0, the function is disabled.

Time Interval:

Set the attendance repeating time interval (Second) of a person. The

attendance will be invalid, the authentication will be failed, and the

door will not be open if the user swipe the card repeatedly within

the time interval. (Set the authentication mode to Card).

Note: The time interval should be between 0 and 255s.

Attendance

Record Prompt:

If the attendance record memory reaches the configured value, the

system will pop up a prompt to remind you.

Note: The maximum attendance record memory is 150,000.

Secure Door

Control Panel:

Enable/disable the secure door control panel. The terminal connects

to the secure door control panel via the RS-485. And the terminal

will receive the magnetic signals, the door opening button signal and

the input/output alarm signals via the secure door control panel.

When disabling the function, the terminal can control these signals

directly.

Record Delete:

When enabling the function, the terminal will delete the first 3000

attendance records, if the memory reaches the configure threshold,

to save the new attendance records. By default, the function is

enabled. For detailed information, see C.2 Disabling Record Delete.

Managing Data

Purpose:

You are able to delete the storage data of the device, including the event, the attendance data, the

user, and the permission.

Steps:

1. Move the cursor to Data and press the OK key to enter the Data interface.

2. Select a data type and press the OK key to delete.

Delete Event Only:

Delete all recorded events in the device.

Delete Attendance

Delete all attendance data in the device or delete

HIKVISION UD06644B User Manual

Other manuals for HIKVISION UD06644B