3.3 Drying system: what to do if. . .
The machine doesn’t dry well
1. The machine is switched off ⇒ Switch on the machine.
2. The machine doesn’t switch on ⇒ Refer to the proper section (see section
3.1 at page 9).
3. The recovery tank is full ⇒ Empty the recovery tank following
the proper procedure.
4. The vacuum motor doesn’t switch
on
⇒ Refer to the proper section (see section
3.3 at page 14).
5. The machine is in ”ECO” mode ⇒ Set up the machine as per standard
configuration.
6. The squeegee is lifted up from the
floor
⇒ Lower down the squeegee.
7. The squeegee rubber blades are
worn out or broken
⇒ Rotate or replace the squeegee rub-
ber blades.
8. The squeegee is not properly ad-
justed
⇒ Adjust the squeegee properly follow-
ing the proper procedure (see section 7.3.1
at page 51).
9. The squeegee vacuum chamber or
adapter is stuck or dirty
⇒ Clean the squeegee vacuum cham-
ber (see section 7.4.1 at page 52).
10. The vacuum hose is stuck or bro-
ken
⇒ Clean or replace the vacuum hose.
11. The vacuum hose is not properly
fitted in
⇒ Connect the vacuum hose properly.
12. The intake manifold is stuck or bro-
ken
⇒ Clean or replace the intake manifold
(see section 7.4.6 at page 53).
13. The intake manifold is not properly
connected
⇒ Connect the intake manifold prop-
erly.
14. The vacuum filter is dirty or stuck ⇒ Disassemble and clean the vacuum
filter.
15. The vacuum cover is not well posi-
tioned or is missing
⇒ Position properly the vacuum cover.
16. The vacuum cover gasket doesn’t
adhere properly
⇒ Replace the vacuum cover gasket.
13
To Next Page
