HIMA HIMatrix F30 011 - Equipment, Scope of Delivery; IP Address and System ID (SRS)

F30 01 3 Product Description
HI 800 145 E Rev. 2.00 Page 15 of 52
3.2 Equipment, Scope of Delivery
The following table specifies the available controller variants:
Designation Description
F30 01 Controller (20 digital inputs, 8 digital outputs),
Operating temperature: 0...+60 °C,
for ELOP II Factory programming tool
F30 011
(-20 °C)
Controller (20 digital inputs, 8 digital outputs),
Operating temperature: -20...+60 °C,
for ELOP II Factory programming tool
F30 014 Controller (20 digital inputs, 8 digital outputs),
Operating temperature: -25...+70 °C (temperature class T1),
Vibration and shock tested according to EN 50125-3 and EN 50155,
class 1B according to IEC 61373,
for ELOP II Factory programming tool
F30 01
SILworX
Controller (20 digital inputs, 8 digital outputs),
Operating temperature: 0...+60 °C,
for SILworX programming tool
F30 011
SILworX
(-20 °C)
Controller (20 digital inputs, 8 digital outputs),
Operating temperature: -20...+60 °C,
for SILworX programming tool
F30 014
SILworX
Controller (20 digital inputs, 8 digital outputs),
Operating temperature: -25...+70 °C (temperature class T1),
Vibration and shock tested according to EN 50125-3 and EN 50155,
class 1B according to IEC 61373,
for SILworX programming tool
Table 4: Available Variants
3.2.1 IP Address and System ID (SRS)
A transparent label is delivered with the device to allow one to note the IP address and the
system ID (SRS for system rack slot) after a change.
IP___.___.___.___SRS____.__.__
Default value for IP address: 192.168.0.99
Default value for SRS: 60 000.0.0
The label must be affixed such that the ventilation slots in the housing are not obstructed.
Refer to the First Steps manual of the programming tool for more information on how to modify
the IP address and the system ID.