HIMA HIMatrix F30 011 - Table 8: System Leds with CPU os up to V6

3 Product Description F30 01
Page 20 of 52 HI 800 145 E Rev. 2.00
System LEDs with CPU OS up to V6.x
While the system is being booted, all LEDs are lit simultaneously.
LED Color Status Description
On Device in RUN, normal operation
A loaded user program is being processed.
Blinking Device in STOP. No user program is being processed.
RUN Green
Off The device is in the ERROR STOP state, see ERROR LED.
On
Internal module faults detected by self-tests, e.g., hardware or cycle
time overrun.
The CPU stopped the user program execution, terminated all hardware
and software tests and reset all outputs.
The processor system can only be restarted with a command from the
PADT (reboot).
ERROR Red
Off No faults detected.
On A new configuration is being loaded into the device.
Blinking
A new operating system is being loaded into the flash ROM. The LED
also blinks during the device's initialization phase.
PROG Yellow
Off No configuration or operating system is being loaded.
On The device is in RUN, forcing was activated.
Blinking
The device is in STOP, forcing has been prepared and is activated
when the device is started.
FORCE Yellow
Off Forcing is not activated.
On
 Line control fault indicator
 The user program caused a fault.
 The device configuration is not valid.
 Loading of the new operating system was not successful and the
operating system is corrupted.
Blinking
 While the operating system was being updated, a fault occurred
during the write cycle of a flash ROM.
 One or multiple I/O faults occurred.
FAULT Yellow
Off None of the described faults occurred.
Blinking Operating system emergency loader active. OSL Yellow
Off Operating system emergency loader not active.
Blinking OS and OSL binary defective or hardware fault, INIT_FAIL. BL Yellow
Off None of the described faults occurred.
Table 8: System LEDs with CPU OS up to V6