F30 01 4 Start-up
HI 800 145 E Rev. 2.00 Page 33 of 52
4.3.2 Digital Inputs for F30
The following tables present the statuses and parameters for the input module (DI 20) in the
same order as given in the Hardware Editor.
4.3.2.1 Tab Module
The Module tab contains the following system parameters:
System parameter
Data
type
R/W Description
DI Number of
Pulsed Channels
USINT W Number of pulsed outputs (supply outputs)
Coding Description
0
No pulsed output planned for SC/OC
1)
detection
1 Pulsed output 1 planned for SC/OC
1)
detection
2
Pulsed output 1 and 2 planned for SC/OC
1)
detection
… …
8
Pulsed outputs 1...8 planned for SC/OC
1)
detection
Pulsed outputs must not be used as safety-related outputs!
DI Pulse Slot UDINT W Pulse module slot
(SC/OC
1)
detection), set the value to 3
DI Pulse Delay [µs] UINT W
Waiting time for line control (detection of short-circuits or cross-
circuits)
DI.Error Code WORD R Error codes for all digital inputs
Coding Description
0x0001 Fault within the digital inputs
0x0002 FTT test of test pattern faulty
Module Error Code WORD R Module error code
Coding Description
0x0000 I/O processing, if required with errors
see other error codes
0x0001 No I/O processing (CPU not in RUN)
0x0002 No I/O processing during the booting test
0x0004 Manufacturer interface operating
0x0010 No I/O processing: invalid configuration
0x0020 No I/O processing: fault rate exceeded
0x0040/
0x0080
No I/O processing: configured module not
plugged in
Module SRS [UDINT] R Slot number (System Rack Slot)
Module Type [UINT] R Type of module, target value: 0x00A5 [165
dec
]
1)
SC/OC (SC = short-circuit, OC = open-circuit)
Table 25: SILworX - System Parameters for Digital Inputs, Module Tab
To Next Page
Loading...
