F30 01 4 Start-up
HI 800 145 E Rev. 2.00 Page 37 of 52
4.4 Configuration with ELOP II Factory
4.4.1 Configuring the Inputs and Outputs
The signals previously defined in the Signal Editor (Hardware Management) are assigned to the
individual channels (inputs and outputs) using ELOP II Factory. Refer to the system manual for
compact systems or the online help for more details.
The following chapter describes the system signals used for assigning signals in the controller.
4.4.2 Signals and Error Codes for the Inputs and Outputs
The following tables specify the system signals that can be read and set for the inputs and
outputs, including the corresponding error codes.
In the user program, the error codes can be read using the signals assigned within the logic.
The error codes can also be displayed in ELOP II Factory.
To Next Page
Loading...
