HIMA HIMatrix F30 011 User Manual

F30 01 1 Introduction
HI 800 145 E Rev. 2.00 Page 5 of 52
1 Introduction
This manual describes the technical characteristics of the device and its use. It provides
information on how to install, start up and configure the module.
1.1 Structure and Use of this Manual
The content of this manual is part of the hardware description of the HIMatrix programmable
electronic system.
This manual is organized in the following main chapters:
 Introduction
 Safety
 Product Description
 Start-up
 Operation
 Maintenance
 Decommissioning
 Transport
 Disposal
HIMatrix controllers are available for the programming tools SILworX and ELOP II Factory.
Which programming tool can be used, depends on the processor operating system of the
HIMatrix controller, refer to the following table:
Programming tool Processor operating system Communication operating system
SILworX CPU OS V7 and higher COM OS V12 and higher
ELOP II Factory CPU OS up to V6.x COM OS up to V11.x
Table 1: Programming Tools for HIMatrix Controllers
In the manual, the differences are specified by using:
 Separated chapters
 Tables differentiating among the versions
i
Projects created with ELOP II Factory cannot be edited with SILworX, and vice versa!
i
Compact controllers and remote I/Os are referred to as devices.

HIMA HIMatrix F30 011 Specifications

General

Brand	HIMA
Model	HIMatrix F30 011
Category	Controller
Language	English