HIMA HIMatrix F30 011 - Communication; Connections for Ethernet Communication

3 Product Description F30 01
Page 22 of 52 HI 800 145 E Rev. 2.00
3.4.2 Communication
The controller communicates with remote I/Os via safeethernet.
3.4.2.1 Connections for Ethernet Communication
Property Description
Port 4 x RJ-45
Transfer standard 10BASE-T/100BASE-Tx, half and full duplex
Auto negotiation Yes
Auto crossover Yes
IP address Freely configurable
1)
Subnet mask Freely configurable
1)
Supported protocols
 Safety-related: safeethernet
 Standard protocols: Programming and debugging tool (PADT),
OPC, Modbus TCP, TCP-SR, SNTP, EtherNet/IP
2)
1)
The general rules for assigning IP address and subnet masks must be adhered to.
2)
EtherNet/IP is not supported in SILworX.
Table 12: Ethernet Interfaces Properties
Two RJ-45 connectors with integrated LEDs are located on the top and on the bottom left-hand
side of the housing. Refer to Chapter 3.4.1.3 for a description of the LEDs' function.
The co
nnection parameters are read based on the MAC address (media access control
address) defined during manufacturing.
The MAC address for the controller is specified on a label located above the two RJ-45
connectors (1 and 2).
Figure 7: Sample MAC Address Label
The controller is equipped with an integrated switch for Ethernet communication. For further
information on the integrated switch and safeethernet, refer to Chapter Communication of the
system manual for compact systems (HI 800 141 E).