Hioki 3561 - Query Comparator Judgment Results; Execute Statistical Functions; Clear Statistical Calculation Results

7.6 Message Reference
124
Query Comparator Judgment Results
(Resistance Measurement)
Syntax
Query
:CALCulate:LIMit:RESistance:RESult?
Response <HI/ IN/ LO/ OFF/ ERR>
Example
Query
:CALC:LIM:RES:RES?
Response
HI
(Voltage Measurement)
Syntax
Query
:CALCulate:LIMit:VOLTage:RESult?
Response <HI/ IN/ LO/ OFF/ ERR>
Execute Statistical Functions
Syntax
Command
:CALCulate:STATistics:STATe <1, 0, ON or OFF>
Query
:CALCulate:STATistics:STATe?
Response <ON or OFF>
Example
Command
:CALC:STAT:STAT ON
Query
:CALC:STAT:STAT?
Response
ON
About the Statistical Calculation function
Data samples can be acquired by the following three methods:
• Press the
TRIG key
• Apply an EXT I/O TRIG signal
• Send the
∗TRG command
The
:CALCulates:STATistics:STATe command does not
clear calculation results.
When the valid data count is zero,
σ
n-1
returns 0.
Clearing calculation results does not disable the Statistical
Calculation function.
The upper limit of Cp and CpK is 99.99. Cp and CpK values
greater than 99.99 are returned as 99.99.
The lower limit of Cp and CpK is 0. Cp and CpK values less than 0
are returned as 0.00.
Clear Statistical Calculation Results
Syntax
Command
:CALCulate:STATistics:CLEAr