2.1 Pre-Operation Inspection
17
1
2
3
4
5
6
7
8
9
10
11
Measurement
Before using the instrument the first time, verify that it
operates normally to ensure that the no damage occurred
during storage or shipping. If you find any damage, con-
tact your dealer or Hioki representative.
Inspection
Operation Check
If the operation check reveals any abnormalities, stop the
check immediately and do not use the instrument.
Required equipment:
• Model 3801-50 (this instrument)
• Model 3851-10 TEST LEAD
• AC power receptacle
(100 V AC 50/60Hz commercial power supply)
1. Set the function switch to "Ω".
2. Press the SHIFT key to conduct the continuity check.
( lights.)
2.1 Pre-Operation Inspection
• Is the battery indicator ( ) lit?
→If it is lit, replace the battery.
(81 page)
• Is the instrument damaged or
cracked in any way?
• Is any of the internal circuitry
exposed?
→Contact your dealer or Hioki rep-
resentative.
• Are any metal parts exposed?
• Is any of the wiring damaged?
→Contact your dealer or Hioki rep-
resentative.
To Next Page
Loading...
