Hioki 3801-50 - Manual Range Function

34
2.12 Pulse Output Function
The pulse output function can be used as a signal source
for checking a variety of pulse signal equipment. The
amplitude is fixed to 0 to 2.8 V, while the frequency and
duty ratio (or pulse width) can be varied.
2.12 Pulse Output Function
1.
Set the function switch.
2. Press the HOLD key , the REL key
or
the Hz key to set the frequency in th
e
main display.
3. Press the SHIFT key to select eith
er
the pulse width or the duty ratio f
or
the sub display.
4. Press the RANGE key or the DUAL ke
y
to set the duty ratio (pulse width)
in
the sub display screen.
5. Connect the test leads to the test te
r-
minals.
6. Connect the test lead to the outp
ut
target.
OUT
HOLD
or REL key
SHIFT
RANGE
or DUAL key
Black
Red