Hioki 3801-50 - Manual Range Function

38
3.2 Manual Range Function
Press the RANGE key to set the manual range function.
Each time the key is pressed the range increases, and
the position of the decimal point changes. Use this func-
tion when you know the strength of the input signal.
To change to auto range, hold down the
RANGE key.
3.2 Manual Range Function
5 V range
51 V range
1000 V range
510 V range
RANGE
• When using the continuity check function, manual
range is the initial setting. When using except for the
continuity check function, Auto range is the initial set-
ting.
• Auto range is not available for nS measurement,
diode check, temperature measurement, and DUTY
ratio measurement.