Hioki PW3360-20 - Chapter 7 Quick Set; Settings Configured with the Quick Set

7.1 Settings Configured with the Quick Set
109
3
Chapter 7 Quick Set
7
The Quick Set offers step-by-step guidance on the minimum necessary
tasks that must be accomplished in order to perform recording and mea-
surement in the following order: [Basic Set]→[Connect]→[U Wir-
ing]→[I Wiring]→[I Range]→[I Check]→[Rec Set]→[Start].
See:Measurement Guide (published separately in color)
When not using the Quick Set, configure all settings as desired.
See:"Measurement Flowchart" (p. 9)
See:Chapter 4, "Changing Settings" (p. 61)
The settings listed below can be configured with the Quick Set. To configure other
settin
gs, exit the Quick Set without starting recording after proceeding to [Quick Set
8/8, Start] and add the desired settings.
See: 7.2, "Settings That Can Be Added to Quick Set Settings" (p. 110)
Quick Set Chapter 7
7.1 Settings Configured with the Quick Set
• Wiring
(1P2W/1P3W/3P3W2M/3P3W3M/3P4W)
• Clamp sensor
• Clock
• Current range
• Save interval time
• Save item
• Recording start method
• Recording stop method
• File name