Hioki PW3360-20 - Measurement Flowchart; Preparation and Connection Steps

Measurement Flowchart
9
This section presents a series of instrument operations without using the Quick Set
function. For more information about the Quick Set function, see the Measurement
Guide (published separately in color).
Measurement Flowchart
Wiring check (p. 56)
Setting the current range (p. 54)
Turning the power on (p. 38)
(At purchase)
• Secure the voltage cords together with a spiral tube. (p. 22)
• Wrap the color spiral tubes around the clamp sensor cables. (p. 23)
• Grouping together clamp cables (p. 23)
• Install the battery pack. (p. 24)
• Setting the language and measurement line frequency (p. 28)
Pre-Operation Inspection (p. 29)
Inserting an SD memory card (p. 30)
Supplying power (p. 33)
Connecting to measurement lines (p. 51)(p. 52)
Setting measurement conditions on the Wiring Diagram Screen (p. 43)
Attach voltage cords (p. 47)
Connecting clamp sensors (p. 49)
Wiring Check screen
Measurement preparations
Connecting to lines to be measured and check