Hioki PW3360-20 - Chapter 12 Specifications; 12.1 General Specifications

167
Chapter 11 Using Pulse Input and Output
11
The pulse I/O terminals can be used to input a pulse signal from an external source
or to output a pulse signal that is proportional to active energy during recording and
measurement.
Using Pulse Input 
and Output
Chapter 11
Wire
External device
Wire the instrument to an external device. (p. 168)
1
Configure the instrument’s pulse settings. (p. 169)
2
Use pulse input (p. 170) or output (p. 172).
3
Pulse signal input
Pulse signal output
Pulse output
device
Input a pulse signal from an external
source. After configuring scaling (coeffi-
cient), sub-unit, and unit (five byte charac-
ters) settings, you can convert and
measure an input pulse signal. After re-
cording and measurement are started,
pulse input values are saved for each
save interval.
See: 11.3, "Inputting a Pulse Signal" (p. 170)
Pulse input
Pulse output
A pulse signal is output each time active
energy consumption (WP+) exceeds the
pulse output rate during recording and
measurement. The output rate can be set
from 1 Wh to 1,000 kWh.
See: 11.4, "Outputting a Pulse Signal" (p.
172)
Pulse counter