10.7 Remote Control of the Instrument by Internet Browser
164
If the HTTP screen is not displayed
Check Internet Explorer’s settings.
Check the LAN settings.
1
On the Internet Explorer settings, click [Tools]-[Internet Options].
2
On the [Advanced] tab, enable [Use HTTP1.1] and disable [Use HTTP1.1
through proxy connections].
3
Under [LAN settings] on the [Connections] tab, disable the [Proxy
server] setting.
1
Check the instrument’s LAN settings and the computer’s IP address.
See: "Configure the Instruments LAN Settings" (p. 156)
2
Verify that the LINK LED on the LAN interface is on and that the Web
mark is being shown on the instrument’s screen.
See: "Connecting the Instrument and Computer with a LAN Cable" (p. 158)
Be sure to restart the instrument after configuring the LAN set-
tings. Failure to do so will prevent the LAN settings from taking
effect, making communication impossible.
To Next Page
Loading...
