3.8 Verifying Correct Wiring (Wiring Check)
57
3
Chapter 3 Connecting to Lines to be Measured
3
4
If the wiring confirmation result is red (FAIL) or yellow (CHECK)
Press [CHK ITEM] so that
you can move the cursor to the
wiring check items.
5
Move the cursor to the item that
has been tagged as red (FAIL) or
yellow (CHECK) and press the
[ENTER] key.
A dialog box with helpful information for
fixing the wiring will be displayed. Re-
view its content.
6
Press the key to close the dialog box.
Review similar information for other wiring confirmation items as necessary.
7
Press the key to display the [WIR, DIAG] screen and check the
actual wirings against the diagram shown on the screen.
8
Fix any incorrect wirings and check the [WIR, CHK] screen again.
To Next Page
Loading...
