Virtual Private Network > Connections
Virtual Private Network
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
225
Buttons
Margintime [s] Specifies the period in seconds, before "IKE Lifetime [s]" and "IPSec
Lifetime [s]" expire, in which the device attempts to negotiate a new key.
Possible values:
1..1800
(default setting:
150
)
The default setting is equal to 2.5 minutes. The maximum value is half
an hour.
Log informational Activated/deactivates event log entries for debugging proposes only.
Possible values:
marked
The device receives and processes the informational messages for this
VPN tunnel, and enters the message in the event log.
unmarked
(default setting)
The device receives and processes the informational messages for this
connection, without an event log entry.
Log not-handled Activates/deactivates message handling for messages unknown to
strongSwan for debugging proposes only.
Possible values:
marked
The device enters the non-strongSwan messages received for this
connection, in the event log.
unmarked
(default setting)
The device ignores the non-strongSwan messages received for this
connection.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Parameters Meaning
To Next Page
Loading...