Routing > Routing Global
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
277
ICMP Filter
Parameters Meaning
Send Echo Reply Activates/deactivates the responding to pings on the router interfaces.
Possible values:
marked
(default setting)
Responding to pings is active.
The device reacts to received “IPv4 Echo Requests” and responds
with an “ICMP Echo Reply” message.
unmarked
Responding to pings is inactive.
Send Redirects Activates/deactivates the sending of “ICMP Redirect” messages on the
router interfaces.
Possible values:
marked
(default setting)
The sending of “ICMP Redirect” messages is active.
In the
Routing > Interfaces > Configuration
dialog, you have the
option of individually activating the sending on every router interface,
see the "ICMP Redirects" function.
unmarked
The sending of “ICMP Redirect” messages is inactive.
This setting prevents the multiplication of data packets, if both
hardware and software functions of the device forward a copy of same
data packet.
Rate Limit Interval
[ms]
Specifies the average minimum time in milliseconds between sending
ICMP packets. The device sends existing ICMP data packets to each
receiver using a token bucket algorithm.
– In periods without sending ICMP data packets, the device
accumulates tokens to allow bursts.
– In the case of bursts the interval is shorter than specified here.
Possible values:
0..2147483647
(default setting:
1000
)
Rate Limit Burst
Size
Displays the maximum number of ICMP packets, the device sends during
a burst to each receiver.
Possible values:
6
To Next Page
Loading...