Hirschmann HiSecOS EAGLE20 - Page 45

Basic Settings > Load/Save
Basic Settings
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
45
Set Password Encrypts configuration profiles and uses a password to make
unauthorized access more difficult.
 Enter the new password in the "Set Password" dialog.
 When you are changing an existing password, also enter the existing
password.
 Mark the "Save Configuration afterwards" checkbox to use encryption
also for the Selected configuration profile in the non-volatile memory
(
NVM ) and in the external memory.
Note: Use this function solely if a maximum of 1 configuration profile is
stored in the non-volatile memory (
NVM ) of the device. Before creating
additional configuration profiles, decide for or against permanently
activated configuration encryption in the device. Save additional
configuration profiles either unencrypted or encrypted with the same
password.
If you are replacing a device with an encrypted configuration profile, e.g.
due to a defect, you proceed as follows:
 Restart the new device and assign the IP parameters.
 Open the
Basic Settings > Load/Save dialog on the new device.
 Encrypt the configuration profile in the new device - see above. Enter
the same password you used in the defective device.
 Install the external memory from the defective device in the new
device.
 Restart the new device.
When it is restarted, the device loads the configuration profile with the
settings of the defective device from the external memory. The device
copies the settings into the volatile memory (
RAM ) and into the non-
volatile memory (
NVM ).
Note: The prerequisite for loading a configuration profile from the external
memory is that in the
Basic Settings > External Memory dialog the field
in the "Config Priority" column displays the value
first or second .
This value is set as the default setting.
Delete Cancels the configuration encryption in the device.
 Enter the existing password in the "Delete" dialog.
 Mark the "Save Configuration afterwards" checkbox to remove the
encryption also for the Selected configuration profile in the non-
volatile memory (
NVM ) and in the external memory.
Note: If you keep additional encrypted configuration profiles in the
memory, the device prevents you from activating or designating these
configuration profiles as Selected.
Parameters Meaning