Hisun HS 200UTV-2 - Engine and Other Check

Introduction HS 200UTV-2/HS 250UTV-2
1-23
2. Set gear shift lever to the “NEUTRAL”
position.
① Gear shift lever.
(L) Low Range
(H) High Range
(N) “Neutral” position
(R) “REVERSE”
3. Push the accelerator pedal down slowly.
① Speed control pedal
② INCREASE
③ “DECREASE
4. Insert the key into the key switch and turn
it to:
OFF (Stop the Engine)
ON (Engine runs or headlights on)
START (Start the Engine)
◆ Engine and other Check Lamps:
The parking brake warning lamp (1 parking
brake) comes on while parking brake is
applied and goes off when it is released.
IMPORTANT :
 Relying on the engine warning lights is
never enough. Never fail to conduct daily
checks carefully by referring to Pre
Operation Check “ in “PERIODIC
SERVICE” section.