Hisun HS 200UTV-2 - Accelerator Pedal; Stopping; Fuel Gauge; Coolant Temperature Gauge

Introduction HS 200UTV-2/HS 250UTV-2
1-29
release button and push down on the parking
brake lever. Make sure that the indicator in the
instrument panel goes off.
① Parking brake lever
② “RELEASE”
■ Accelerator Pedal
The Accelerator pedal is used to increase the
engine and vehicle speed. Push down on it for
higher speed.
① Accelerator pedal
STOPPING
■ STOPPING
1. Release the speed accelerator pedal
2. Step on the brake pedal.
CHECK DURING DRIVING
■ Immediately Stop the Engine if：
 The engine suddenly slows down or
accelerates.
 Unusual noises are suddenly heard.
 Exhaust fumes suddenly become very
white.
While driving, check the following items to see
if all parts are functioning normally.
■ Fuel Gauge
Park the vehicle on a flat place.
When the key switch to “ON”, the fuel gauge
will indicate the fuel level.
Be careful not to fully empty the fuel tank.
Otherwise air may enter the fuel system.
① Fuel gauge
■ Coolant Temperature Gauge