Hisun HS 200UTV-2 - Brake Pedal

Introduction HS 200UTV-2/HS 250UTV-2
1-27
 “ON” position.
If the emergency light switch is pressed to
the “ON” position while the turn signal is
activated, the indicated turning light will
flash and other will stay on.
 Be sure to return switch to center position
after turning.
① Engine Speedometer
② Emergency light lamp
③ Speedometer
④ Low beam, High beam
⑤ headlight switch
⑥ Key switch
① Head light ② Head turn signal lamp;
③ Tail turn signal lamp
3. Checking the brake pedal.
■ Brake Pedal
CAUTION:
To avoid personal injury:
 If the operator suddenly brakes, an
accident may occur due to loss of
control or the shifting forward of heavy
loads.
 When driving on icy, wet or loose
surface, make sure the vehicle is
correctly loaded to avoid skidding or
loss of steering control. Reduce the
speed.
The brake pedal is the left pedal on the foot
board. Depress the pedal to slow or stop the
vehicle.