Hisun HS 200UTV-2 - Gear Shift Lever

Introduction HS 200UTV-2/HS 250UTV-2
1-28
① Brake pedal
4. Selecting the correct gear.
■ Gear Shift Lever
CAUTION:
To avoid personal injury:
 Avoid changing gears when ascending
or descending a slope.
 Before ascending or descending a
slope, shift to the “L” range to control
the vehicle speed.
 If you shift gears while ascending or
descending a slope, be prepared to
use the brake to maintain control.
 Operate in reverse at slow speeds to
maintain control.
1. The gear shift lever can only be shifted
when the vehicle is completely stopped
and the brake pedal is pressed.
2. To avoid transmission and shift linkage
damage, completely stop the vehicle
using the brake pedal before shifting
gears.
3. Select proper gear depending on the
types of job.
4. Before exiting vehicle, shift the gear shift
lever to the “NEUTRAL” position and set
parking brake.
① Range gear shift lever
(L) LOW Range
(H) HIGH Range
(N) NEUTRAL” POSITION
(R) “REVEREE”
NOTE:
 When gear shift lever is hard to engage,
do not force the lever. Set the parking
brake, slightly depress the accelerator
pedal and release it to neutral position,
then shift the lever.
When the lever is hard to disengage, do
not force the lever.
 Depress the brake pedal fully, then shift
the lever. Damage may occur with wrong
shifting operation.
 AN accident could occur through improper
use of the gear shift lever
5. Release the parking brake and start
slowly.
To release the parking brake, depress the
brake pedal, push release button and push