Hisun HS 200UTV-2 - Head Light Switch; Emergency Light Switch; Turn Signal Light Switch

Introduction HS 200UTV-2/HS 250UTV-2
1-26
2. Selecting light switch position.
■ Head Light Switch
Turn on the key switch and toggle the head
light switch to the “ON” position.
Toggle the head light switch to the “OFF”
position to turn off the head light.
① Head light switch
② Low beam; High beam
NOTE：
Turning the head light switch to the “ON”
position causes the following lamps to light
simultaneously.
1. Tail lights (lamps at the rear portions of the
vehicle)
2. Lamp built in the coolant temperature
gauge
3. Lamp built in the fuel gauge
4. Lamp built in the speedometer
■ Emergency Light Switch
Press the top half of the emergency light
switch, the light flash along with the indicator
on the instrument panel. Press the bottom half
of the emergency light switch to turn off the
light.
Note:
 The emergency light switch will operate
when the key switch is in the “ON” position
and "OFF" position. Keeping the switch
“ON” causes the battery to run out.
■ Turn Signal Light Switch
To indicate a right turn, push on the lower half
of the turn toggle switch.
To indicate a left turn, push on the upper half of
the turn toggle switch.
When the left or right signal is activated, the
indicated turning light will flash and the other
will stay on.
The indicator lamp at the instrument panel also
flashes indicating the direction of the turn.
NOTE:
 The turn signal light switch is only
operative when the key switch is in the