Hitachi C 10FCD - SPECIFICATIONS

9
English
SPECIFICATIONS
Item Model C 10FCD
Motor Type Series co m mutator motor
Po w er source Single-phase A C 60Hz
Voltage (Volts) 115
Full-load current (A mp) 13
Applicable Outside Dia. 10" (255 m m)
sa w blade Hole Dia. 5/8" (15. 9 m m)
No load speed 3800rpm
Miter 0°
Max. Height 2-23/32" (69 m m) *M ax. Height 3-1/2" (89 m m)
Bevel 0°
Max. Width 5-5/8" (143 m m)
(
*M ax. Width 3-5/8" (92 m m)
)
Miter 45°
Max. Height 2-23/ 32" (69 m m)
Max. Width 3-7/8" (98 m m)
Miter 0°
Max. Height 1-25/ 32" (45 m m)
Max. sawing Left
Max. Width 5-5/8" (143 m m)
dim ensions Bevel 45°
Miter 45°
Max. Height 1-25/ 32" (45 m m)
Max. Width 3-7/8" (98 m m)
Miter 0°
Max. Height 15/16" (24 m m)
Right
Max. Width 4-3/4" (120 m m)
Bevel 45°
Miter 45°
Max. Height 15/16" (24 m m)
Max. Width 3-11/32" (85 m m)
Miter sa wing range Left 0° – 45°, Right 0° – 45°
Bevel sawing range Left 0° – 45°, Right 0° – 45°
Co m pound sawing range Left (Bevel) 0° – 45°, Left and Right (Miter) 0° – 45°
Right (Bevel) 0° – 45°, Left and Right (Miter) 0° – 45°
Net w eight 28. 7 lbs. (13 kg)
Cord 2 Conductor type cabtire cable 6. 6 ft (2 m)
*N ote: 11/16" (17 m m) thick spacer board is required to be attached to the fence.
ACCESSORIES
WARNING: Accessories for this power tool are mentioned in this Instruction Manual.
The use of any oth er attachment or accessory can be dangerous and could cause in jury or
mechanical damage.
STANDARD ACCESSORIES
Fig. 3
e Vise Asse m bly (1 piece)
For how to use, refer to
pag e 15.
t Wrench (1 piece)
q 10" (255 m m) TCT S a w
blad e (1 piece)
w Dust Bag (1 piece)
For how to use, refer to
pag e 19.
r Extension Stay (1 piece)
5 m m M achine Scre w (2
pieces)
For how to use, refer to
pag e 11.
(N o. of teeth 24 Co de N o.
790004)