--- 3 ---
Depth
4-1. Selling Point Descriptions
(1) Compact body thanks to the new sliding system
Operable even in tight places
When moving the motor head, the slide pipe also moves together extending backward in the case of the
conventional slide compound miter saws. The Models C 12LSH and C 12RSH are equipped with the new
system that allows only the motor head to slide from the front to the back. As shown in Fig. 1, the slide pipe
does not extend backward when sliding the motor head from the front to the back. Therefore, the depth of the
main unit remains unchanged (930 mm). The Models C 12LSH and C 12RSH are operable even in tight
places such as a place where there is a wall behind.
1
When the motor head
is at the back position
Dimension of the main unit (Width x Depth x Height)
When the motor head
is at the front position
Fig. 1
Table 1
Model
When the motor head is at the back positionWhen the motor head is at the front position
HITACHI
C 12LSH/C 12RSH
HITACHI
C 12FSA
C
P
595 x 930 x 710
(23-7/16" x 36-5/8" x 27-15/16")
580 x 1,120 x 675
(22-7/8" x 44-3/32" x 29-9/16")
590 x 800 x 690
(23-1/4" x 31-1/2" x 27-1/4")
595 x 910 x 660
(23-7/16" x 35-13/16" x 26")
595 x 930 x 710
(23-7/16" x 36-5/8" x 27-15/16")
580 x 1,120 x 675
(22-7/8" x 44-3/32" x 29-9/16")
590 x 1,035 x 690
(23-1/4" x 40-3/4" x 27-1/4")
595 x 1,120 x 660
(23-7/16" x 44-3/32" x 26")
The slide pipe does
not extend backward.
Unit: mm (inch)
Depth
To Next Page
Loading...
Need help?
General
