Table 2-130 Items in Boot order settings
Item Description
Update boot device information
button
Gets the boot device information again, and
update the dialog box.
When getting the information, it may take
several minutes to complete due to activate and
deactivate LPAR.
LPAR Boot
order
1
Priority Shows the priority level.
Device type Shows the boot device type.
Status Shows the boot device status.
Name Shows the boot device name.
Slot Shows the card type that connects to the boot
device.
Controller
number
[Management module firmware version A0240 or
later]
Shows the controller number that connects
to the boot device.
Scheduling
mode
[Management module firmware version A0240 or
later]
Shows the scheduling mode that connects to
the boot device.
Port Shows the port number that connects to the boot
device.
WWN/MAC Shows WWN or MAC address that is assigned the
port.
LUN Shows the LU number to use as the boot device.
Move selection
up button
Move up the order of selected boot device.
Move selection
down button
Move down the order of selected boot device.
Delete from
boot order
button
Deleted the selected boot device from the boot
order.
USB / HBA /
PXE tab
2
Device type Shows the device type.
Registered Shows the boot order select or not.
Status Shows the assign status of logical port or device.
Assigned: The USB device is assigned. (USB)
---- -: The information cannot be taken due to
the dedicated mode. (HBA, PXE)
Available: Operate normally.(HBA)
ConfigCheck: Cannot be used due to a
configuration problem. (HBA)
Operating the Web Console
2-117
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
