Hitachi Compute Blade 500 Series - Page 168

Table 2-184 Action button at the bottom
Item Description
Edit Edits Optional Physical MAC addresses. Follow instructions shown in the edit
dialog box to type an Optional Physical MAC address.
Initialize Restores the Optional Physical MAC address to the initial factory value.
If you initialize the Optional Physical MAC address when server blades are
switched due to N+M cold standby, the same Optional Physical MAC address
may be created. Make sure not to have the same Optional Physical MAC when
initializing it.
Close Closes this dialog box.
Default Physical MAC
When the primary server blade is selected in SMP configuration, Default
Physical MAC information of all server blades is shown.
Table 2-185 Default Physical MAC List items
Item Description
Table heading Shows the server blade number and mezzanine card number and name.
Controller Shows the number of a network controller installed in the mezzanine
card.
Port Shows the port number.
2-158
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide