Table 2-55 DNS items
Item Description
Priority
(Available only with CB 520X
and CB 520H B3 or later)
Select IPv4 or IPv6.
If IPv4 is selected, BMC will use an IPv4 DNS server
preferentially.
If IPv6 is selected, BMC will use an IPv6 DNS server
preferentially.
DNS(IPv4) DNS
server 1
Type a DNS server IP address. You can set up to three
IPv4 addresses, which will be used from DNS server 1 in
order.
When not setting DNS server 2 and 3, leave those fields
blank. If not using DNS, leave three fields blank.
DNS
server 2
DNS
server 3
DNS(IPv6)
(Available only
with CB 520X and
CB 520H B3 or
later)
DNS
server 1
Type a DNS server IP address. You can set up to three
IPv6 addresses, which will be used from DNS server 1 in
order.
When not setting DNS server 2 and 3, leave those fields
blank. If not using DNS, leave three fields blank.
DNS
server 2
DNS
server 3
Table 2-56 Syslog transfer items
Item Description
Use Enable or Disable Syslog transfer.
When enabled, server blade system logs are transferred to an external
Syslog server.
Target syslog
server
Specify a Syslog server to transfer system logs as IP address in
XXX.XXX.XXX.XXX format or FQDN using up to 127 characters.
Table 2-57 LDAP items
Item Description
LDAP server
settings
Use Select Disable or Enable. With this item
enabled, BMC will use LDAP for SMASH
authentication.
If you enable this item, you cannot use the
RADIUS functionality.
User authentication
method
Select one of the following user authentication
methods.
LDAP authentication only
If Local authentication fails, try LDAP
authentication
LDAP server1 Specify LDAP server(s) as IPv4 address in
XXX.XXX.XXX.XXX format or FQDN using up to
127 characters. BMC uses LDAP (StartTLS) as
LDAP server2
Operating the Web Console
2-53
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
