29
Setting input ports using menu
5.4 Setting the menu - Inputting image to Sub and Main individually (continued)
3.
Use the ▲/▼ buttons to highlight SUB INPUT SOURCE, and press the ►
button to display the SUB INPUT SOURCE dialog.
4.
Use the ▲/▼ buttons to highlight FOLLOW MAIN
UNIT, and press the ► button to complete the set-
ting. (
19
)
5.
Press any button to select an input port on the
remote control or the ,1387 button of the Main
projector. The MAIN INPUT SOURCE dialog will
be displayed on screen.
Use the ▲/▼ buttons
to highlight the port to which the signal cable is
connected, and press the ► button to complete
the setting.
NOTE • If FOLLOW MAIN UNIT is selected, selecting the input source on
either the Main or Sub projector will automatically set the other projector to the
same source.
• If FOLLOW MAIN UNIT is selected, /$1, 86%7<3($ and 86%7<3(%
cannot be selected.
• When FOLLOW MAIN UNIT is selected, if any button to select an input port
on the remote control or the ,1387 button on the Main projector is pressed, the
dialog for selecting the input source will be displayed.
To Next Page
Loading...
