Hitachi CP-X8150 - Page 238

33
Troubleshooting
The STACK
menu cannot
function.
7KHVHWWLQJVRQWKHSURMHFWRUVDUHQRWVHW
IRUWKH,QWHOOHFWXDO6WDFNIHDWXUH
Check the following settings on the Main and
Sub projectors.
- STANDBY MODE in SETUP menu:
NORMAL
- COMMUNICATION TYPE under
COMMUNICATION in SERVICE menu:
OFF
- STACK LOCK in SECURITY menu: OFF

5
The projector
does not respond
to the remote
control.
7KHUHPRWHFRQWUROLVSRLQWHGDWWKH6XE
SURMHFWRU
When operating in Intellectual Stack, only
the Main projector is capable of receiving the
remote control signals. Therefore, point at the
Main projector when using the remote control.

3
The images are
either out of
focus or not well-
superimposed.
7KHWZRLPDJHVDUHQRWVXSHULPSRVHG
FRUUHFWO\
Adjust to superimpose the images with the
ZOOM, FOCUS and LENS SHIFT features.
If necessary, adjust PERFECT FIT and
KEYSTONE as well.

6

11
The images
from the two
projectors do not
superimposed
even after
performing ne
adjustment.
7KHUHDUHVRPHDGMXVWPHQWGLIIHUHQFHVLQ
WKHWZRLPDJHV
Try to resolve the problem with the following
measures.
- Press the AUTO button on the remote
control or execute AUTO ADJUST
EXECUTE on each of the projectors.
- Adjust H POSITION and V POSITION on
each of the projectors.
- Check the RESOLUTION setting in the
INPUT menu, and change to the same
setting if the setting differs between Main
and Sub.

27, 42
in
Operating
Guide

41
in
Operating
Guide

46
in
Operating
Guide
Phenomenon Cases not involving a machine defect
Reference
page
7. Troubleshooting (continued)