Configuring the hardware and installing an operating system
•
Partition Label
Then click the
Create
button to complete.
e.
Repeat step c and d to create more partitions.
Configure Firmware Update
About this task
In this page, the user can choose to
Attempt Firmware Update
.
Procedure
1.
Use the slider available on the screen to update the Firmware.
•
Under the
Name
tab you will see a list of Firmware Updates available.
•
Under the
Available
and
Current
tab you can compare the version number.
2.
Click the check box in front of the
Firmware name
to choose the firmware you want to update.
Reviewing your settings
About this task
CAUTION:
Continuing past this screen resets the drives to a newly installed state and installs the selected OS. Any
existing information on the server is erased. This action does not affect the first-time setup, because there is no
data present on the server.
Procedure
1.
Review and confirm your deployment settings.
2.
Click
Back
to navigate to the
Summary and Install
button on the top-right corner.
3.
Review the setting from the
Summary and Install
menu.
4.
Click the
Accept Configure
button on the top-right corner to process the OS installation.
NOTE:
If
firmware update
is enabled, a popup for token authorization will been shown. Please follow the steps in
Firmware Update
section for detail.
Checking installation parameters
During the installation and configuration process, consider the following:
•
A EULA might be displayed.
•
If you attempt to deploy an OS on a server with no installed drives, it will show up an error message stating Rapid
Setup did not find any supported disk installed on this system, and the user will not be able to proceed.
•
For Windows installations, messages about an untested Windows version and hpkeyclick messages might be displayed
while the drivers are installed. This is expected behavior. No action is required.
To Next Page
Loading...
