Hitachi HA800 G3 Series - Intelligent Provisioning Does Not Reimage AOIP; Accessing Version Information in Deployment Settings

Troubleshooting 43
The system boots from the USB key and installs IP Recovery. When the installation is complete, the utility prompts you
to remove the USB key.
5. Remove the USB key.
6. Reboot the system and press F10 (IP Recovery) to verify IP Recovery launches properly.
Solution 2
Cause
The iLO is running in FIPS mode.
Action
1. Enter the iLO configuration screen and turn off FIPS mode.
2. Boot the server into F10 mode.
3. After making all changes, enable FIPS mode.
Intelligent Provisioning does not reimage AOIP
Symptom
Intelligent Provisioning PXE flashing does not reimage Always On Intelligent Provisioning.
NOTE: The user can follow the command lines only for the reference from Grub menu.
Action
Update the Kernel command line with the word "Install". For example:
linuxefi /IP3.30/vmlinuz media=net splash quiet iso1=http://
192.168.100.101/iso/IP330.2019_0103.230.iso iso1mnt=/mnt/bootdevice
nicmac=5c:b9:01:c5:43:d0 install
echo 'Loading initial Ramdisk...'
initrdefi /IP3.30/initrd.img
NOTE: Modify the command as per the system requirements.
Accessing version information in deployment settings
Symptom
Version information for the Deployment settings utility is blank.
Cause
Version information is no longer located in the Deployment settings utility.
Action
Click the System Information icon at the top of the screen for version information.