Hitachi Advanced Server HA820 G2 User Guide 19
Description Status
Power supply LEDs Off = Normal
Solid amber = Power subsystem degraded, power supply failure, or input
power lost.
PCI riser LED Off = Normal
Amber = Incorrectly installed PCI riser cage
Over temp LED Off = Normal
Amber = High system temperature detected
Power cap LED Off = System is in standby, or no cap is set.
Solid green = Power cap applied
Amp Status LED Off = AMP modes disabled
Solid green = AMP mode enabled Solid amber = Failover
Flashing amber = Invalid configuration
1
. Embedded NIC ports are not equipped on the server. NIC LEDs on the Systems Insight Display will
flash based on the network adapter port activity. In the case of a dual-port adapters, only NIC LED
1
and
2
will illuminate to correspond with the activity of the respective network ports.
When the health LED on the front panel illuminates either amber or red, the server is experiencing a
health event. For more information on the combination of these LEDs, see
Systems Insight Display
combined LED descriptions.
Systems Insight Display combined LED descriptions
The combined illumination of the following LEDs indicates a system condition:
•
Systems Insight Display LEDs
•
System power LED
•
Health LED
Systems Insight
Display LED and color
Health
LED
System
power LED Status
Processor (amber) Red Amber
One or more of the following conditions might
exist:
• Processor in socket X has failed.
• Processor X is not installed in the socket.
• Processor X is unsupported.
• ROM detects a failed processor during
POST.
Processor (amber) Amber Green Processor in socket X is in a pre-failure
condition.
To Next Page
Loading...
