Hitachi HA820 G2 - Installing a DIMM

Hitachi Advanced Server HA820 G2 User Guide 74
Processor TDP DIMM blank installation
105W to 140W Recommended
230W to 270W Recommended
150W to 270W Required
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Open the DIMM slot latches.
6. Install the DIMM blank.
Installing a DIMM
The server supports up to 32 DIMMs.
Prerequisites
Before installing this option, be sure you have the following: The components included with the hardware option
kit.