Hitachi Advanced Server HA820 G2 User Guide 50
4.
Decide how to manage the server:
• Locally: use a KVM switch or a connect a keyboard, monitor, and mouse.
• Remotely: connect to the iLO web interface and run a remote console:
a
Verify the following:
◦ iLO is licensed to use the remote console feature.
If iLO is not licensed, contact customer support.
◦ The iLO management port is connected to a secure network.
b
Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
◦ The hostname is located on the serial pull tab.
◦ If a DHCP server assigns the IP address, the IP address appears on the boot screen.
◦ If a static IP address is assigned, use that IP address.
◦ The default login credentials are located on the serial label pull tab.
c
In the side navigation, click the Remote Console & Media link, and then launch a
remote console.
Power on the server
5.
Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
Update the firmware
6.
Using the SPV, update the following:
•
System ROM
• Storage controller
• Network adapters
• Intelligent Provisioning
Set up storage
7.
Do one of the following:
• To configure the server to boot from a SAN, contact customer support.If a smart array
controller is installed:
o For SR controllers, use smart storage administrator to create arrays:
a.
From the boot screen, press F10 to run Intelligent Provisioning.
b.
From Intelligent Provisioning, run Smart Storage Administrator.
◦ For MR controllers, use the UEFI System Configuration to create arrays.
To Next Page
Loading...
