Hitachi Advanced Server HA820 G2 User Guide 69
4. Attach the -48 V wire and the return wire to the connectors as marked and tighten to 0.98 N m (8.68
lb-in) of torque.
5. Attach the ground (earthed) wire to the ground screw and tighten to 1.47 N m (13 lb-in) of torque.
6. Replace the clear plastic cover on the -48 V and return connectors.
7. Secure the power cord, wires, and/or cables in the strain relief strap attached to the power supply
handle:
a. Unwrap the strain relief strap from the power supply handle.
CAUTION:
Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server
cable. Never bend power cords and server cables tight enough to cause a crease in the sheathing.
b. Secure the wires and cables with the strain relief strap. Roll the extra length of the strap around the
power supply handle.
To Next Page
Loading...
