E9 – Not used
Settings Condition setting
00 Not used
01 Used as setting for conditions 00
EA – Not used
Settings Condition setting
00 Not used
01 Used as setting for conditions 00
Eb – Fan operating control after stoppage of the indoor unit in cooling mode
This function reduces the unit fan speed to reduce the spreading of smells and humidity.
Setting condition
Fan operation with the thermostat switched off
00 Not available
01 Low
02 Slow
EC – Fan operating control after stoppage of the indoor unit in cooling mode
This function is used to force stoppage when cooling is complete. It is effective for avoiding unpleasant smells, as the heat
exchanger remains clean, e.g. it is rinsed with drainage water.
Setting condition
Fan operation with the thermostat switched off
00 Fan at set speed
01 Low
02 Slow
Ed – Not used
EE – Automatic fan speed control
This function is useful to economise the operating time and limit the operating of the unit by automatically controlling the
fan speed when the room temperature is close to the set temperature. The following table shows the change of fan speed:
N O T E
This function is available for PC-ART and all indoor units except RPI(8.0/10.0)FSN2E
The configuration fan speed
Speed setting
High
High→ Medium→ Low
Medium
Medium→ Low
Low Low (no change)
Settings Condition setting
00 Not available
01 Available
F1 – Automatic timer off setting
This function is used to switch off the timer automatically when the unit is started using the remote control.
6 Optional functions
213
SMGB0063 rev. 1 - 10/2010
6
To Next Page
Loading...
